I've done 2 in my SV2, another 2 lads at last round of Worksop that were pitting with me also went through servo gears also in their sv2s......I spoke to Robin Schumacher re this and he advised running a full size servo with slightly higher torque as the lower servos aren't quite up to it!
To be fair, I broke one servo off the main jump so that was my fault, the other wasn't anything dramatic!!
I'm aware that a well known team have done independent testing on torques of servos and they don't perform as well as they say they should!!
I like the low profile servos but if they don't cut the mustard then they must go!!!
|