Hello,
Right I am just getting back into the sport again and have paid for a second hand DB1 with a Tekin speedo and couple of sets of lipo's. I have just sorted a transmitter, receiver and 6.5 turn motor. Final part is a low profile servo which i hope to get sorted this week.
What i now need to do is get the following:
- Tools - what is required, does anyone have a list of allen key sizes and nut drivers?
- Pinions - what are the typical sizes for both indoor and outdoor running the 6.5 motor?
- Spares - what are the common parts that break? I know lots of people run DB1's and RB5's but I like to carry spares.
- Tuning Parts - what springs, anti-roll bars etc are needed?
Final thing, who can advise good base setups for the car?
Oh and only 4 days till i pick the car up......!!
Gareth