Quote:
Originally Posted by moleman
The front hexes in the K1 kit are a little to small for the hex in the TLR22 front wheels.
/Morgan
|
Oh? The front tlr 22 wheels seems to be fitting nicely here. It's the rear ones i've been a bit unsure about, as the nut only get about half of its threads used, but as i've understood now, it should be enough.
Also i was under the impression that the front wheels on 2wd cars were smaller than the wheels on 4wd cars, in total width that is, but that also is false after what i've read. So it looks like am good to go now.
Edit: Or actually, it looks like the front hex on the tlr is 9.8/9.9mm and the hex that comes with the CAT K1 is 9.5/9.6mm so there is a difference, but when putting on the tlr 22 front wheel and screwing in the lock nut, the wheel seems to be sitting very good.