Well ive redesigned my rear gearbox plates slightly and will be my last change.
Ive also had a rethink on the pivot block holding the front of the rear gearbox to the chassis and even though ive designed and having my unique pivot block made i think the easiest way is to change my L brace design so it and the cf motor plate ive done both hold the front section in place solidly and means normal pivot blocks can be used. The rear will be held in place by the rear mount after a tad of dremelling.
Once ive got all the bits made and the new layshaft as well i will be doing a step by step manual on how to build my rear gearbox. It will have a vts slipper attached as well.
|