Servo Wires
I get plenty of Servos ESC etc back where they have failed and its very commonly due to bad job at shortening wires.
I personally never shorten the wires i just gently tuck and tie wrap them out the way.
However if you are very careful and want to gamble you can re-solder and it will work best or the crimping tool is good but i have seen people get that wrong too.
Also bear in mind if you do shorten the wires you wont be covered by Warranty, also if you want to fit the servo in another car the wires could be too short!!
If you are not sure then i strongly suggest not to attempt.
Attached picture from a customer who servo had failed!!
|