I managed to make some more progress this weekend.
I didn't strictly follow the order of assembly in the manual
I started with the genuine lower belt cover which I had cut out earlier and the genuine Kyosho double sided tape
And here it is installed
Next it was time to break out these
Along with these which needed to be installed onto the wishbones
I decided to prep all four wishbones at the same time
Rears installed. I actually had to move the belt cover forward a little, as it was fouling on the rear pivot block, luckily the tape had not stuck that well to the Carbon Chassis and it was not a nightmare to get it off, I managed to get it in just the right place second time round!
Then time to install the rear bulkhead
Followed by the front belt cover retainer
I've never built a LWB Mid before so this was something new to me, I nearly forgot to get one when I was sourcing parts for this build
