[Tweaky]

Barely used speed control, still fitted with standard wiring. Was kept as a spare and is imaculate, working purfectly last time i used it. Sensor lead included, but i dont have the USB interface lead

Box and manual.

£80 includes postage.



Some specs of the Graupner/Schumacher Website
http://www.graupner.de/en/products/f...4/product.aspx



Features:

• Cooler operating temperature due to complete, light aluminium housing and special PCB design with extra-thick copper wires and optimized switching flanks. The flat design provides an extremely low centre of gravity.
• Top efficiency thanks to the new, even faster 16-bit processor and optimized software with newer, simpler operating software; providing longer operating time and greater performance
• For brushless motors (see operating voltage) and brushed motors (up to 7.4V)
• Telemetry functions
• Automatic Hall sensor detection
• Storage/read-out of max rpms, maximum current, and temperature
• New brake and power programmes
• 10 user-programmable modes
• User-updatable firmware
• Soldering socket for easy replacement of wires

Programmable functions:

• On/off function with knob
• Low-voltage cutoff
• Automatically adjustable for Li-/Ni batteries on in 0.1-V steps
• Automatic brake, minimum brake, maximum brake, full brake, ABS braking function
• Maximum reverse; various reverse modes
• Automatic throttle
• Soft start, soft braking
• Current limiting, start-current limiting, turbo
• Transmitter lever positions: full throttle point, zero point, full braking point, zero point width
• Timing, variable timing functions
• 16 power curves for 3T - 21.5T
• Settings for temperature shutoff, sensor mode, braking mode, motor type
• Frequency 0.25 - 32 kHz
• For other functions, see PC software!