Easy chap !
Start with the 4mm Red Positive plug from the charger, plug this into Positive on one of the saddles
Now the 4mm Black Negative plug from the charger, plug this into the Negative on the second saddle
Now you need a link lead, made out of 2 x 4mm Correlly Bullets and a 2mm Female Connector and a small piece of 12awg wire.
Solder the two 4mm's on each side of the 12awg wire, half way up the wire bare a little wire and solder the female 2mm on and heatshrink all bare wire.
Now with the complete link lead, use the two 4mm plugs and connect to the two saddle's, one Negative and the other being Positive terminal of the Saddles.
The final 2mm Connector from the charger connect to the link lead 2mm Female Connector.
Hay Presto, Press Balance Charge on your charger.
Hope I've explained myself clearly.
|