Quote:
Originally Posted by RobW
Hi
I converted my KO Univ 3 a few weeks ago and all good - very easy and works great.
Finally got round to taking my son's Sanwa Gemini II apart tonight to convert that and need a bit of advise as I am no electronics expert. Looked at the pic on page 2 of this thread and my Gemini II is a little different - actually has a different serial number and looks slightly different. Pic attached.
Has anyone actually converted a Gemini II and if so are the three wires as per the picture on page 2? I can see how I would solder to the 2 solder points in the picture but the bottom one just seems to be a small brown circular spot which is not attached to any other part of the board.
Does anyone have any pictures of their conversions.
Thanks
Rob
|
Hi Rob,
i converted a Gemini 2 and a mate has too, they were the same as in both pics...
there is no specific point for the (-) negative earth lead, just scratch the green coating off enough to make a solder point to the board (or use soldering iron to burn it off!), i did i roughly in area shown on pic on page 2 of this thread as it keeps the wires together and neat.