Thanks for the input lads. I'm using corally connectors but they were unsoldered from an old speed control so are a little worn. I shall replace these with new Corally's and resolder the tabs on the motor. The car is doing exactly that, it cuts under hard acceleration, usually at the beginning of the straight under hard acceleration out of a 90 degree corner. I had the cutoff voltage at 3.2 but dropped it to 2.8, how low can I safely go? The car is running 1 tooth lower than the recommended gearing as it was running on a twisty track. Additionally the track was wet so I was being far smooths on the gas but still the problem occurred.
Finally, does this sound more like a glitch or incorrect speedo setup over an actual faulty speedo? It's just that te speedo has only just been returned from Schumacher and I'd hate to have to send it back again.
Chris
|