Quote:
Originally Posted by MHeadling
Gaz, just to add Craig runs an RB5 Vega.
Using B4 parts (motor plate and gear cover) I am sure you could adapt this to the Vega B4.1
Yes the motor screws are what holds the motor plate in position
Get some pics up once you have done it.
|
This will not fit the B4.1 kit. Its possible to do on the RB5 and 201 kits as they both have longer layshafts, and there is space behind the slipper assembly.
On the B4 kit due to the short layshaft the slipper assembly is much closer to the motor plate, no room to place the original B4 motor plate between the Vega motor plate and the B4 slipper assembly.
You can do a similar thing by cutting out a piece of lexan to use as the backing plate though, as thats thin enough to fit (I think)