[oosh123]

Hi guys,

Sorry, I have been off for a while, but I am now 100% back on to the Lazer.

I pulled some strings and was able to get back to my University's engineering department to do some destructive testing on the Lazer to test out my front and rear gear box.

The two tests that I have done are simluation of the Lazer travelling at 50km/h and experiencing crashes. Contacting point of test #1 is the at a point 1/4" inch below the top of the front shock tower. Result, there is no damage to the front gear box, but I need a new front shock tower.

Contacting point of test #2 is again at the 1/4" inch below the rear shock tower. Result, rear gear box is intact with no damage, but I also need a new rear shock tower.

In conclusion, I believe the front & rear gear boxes and also the upper deck mounts are ready.

As stated before prices are below (I understand it's costly, but that's the best I can do):

Front gear Box (4 anodized aluminum, 2 CF pieces, 1 anodized aluminum sheet cover): $140

Upper Deck Mount (1 anodized rearupper deck mount, 4 middle upper deck mount posts): $90

Rear gear box (1 anodized aluminum base, 4 anodized aluminum cross bar, 4 spacers, 1 anodized aluminum reartower mount, 1 anodized belt tension bearing holder, 2 CF side plates, 1 CF belt tensioner): $160

Motorplate (1 anodized aluminum motorplate with heat sink): $75

Blue Belt: $25/set

Shipping cost from supplier to me will be distributed amongs the orders.

PM me if you are interested. I will take front & rear gear box, upper deck mount, motorplate orders until Sept 14 because of the expensive shipping fee that my supplier charges me and not know if I when I will make another order. As for belts, I stocked them.