[Nigel]

Yes I know there are many threads on this but I have tried almost all the suggestions and even some of my own methods with no success. I still have then fall out after around 2 heats or a main.

So far I have tried using, Blue lock loctite, Red loctite, CA glue and Heat-shrink + Red loctite.

The problem I find with the Heat-shrink is that if you dont put it on the axle joint far enough it will end up sliding off, and if you put it on too far it gets torn apart by the bearings/hub.


Any suggestions other than rebuilding all four CVD drive shafts after every heat?

Thanks!