Quote:
Originally Posted by OneKiwi
I have a 210 and the drive pins on the dog bones are looking a bit flat on one side.
Im thinking about swapping them for new ones, same with the outdrives and am wondering how do you take them out and put in fresh ones?
I will also look at doing the 410 as well when the need doing.
Is there a good tool?
A DIY tool?
|
this is the ultimate,
http://www.hudy.net/xhudy/products/p...71&kategoria=0
a guy called Dave grunil also makes a good one which i have, go to a good bearing suppliers and the pins are pence (do not hear the shaft it alters the hardness and can stretch the hole)
i can get you daves contact info if you wish.
defo worth doing i saved £££'s by changing pins in my xray ic drive shats and once you have the tool and pins other will pay to save £'s