Quote:
Originally Posted by JohnW
Sorry. Pressed the wrong button. As I was saying I have just measured one at 15.7mm ( plus or minus 0.1mm) . It probably came off a BK1 but I think they are the same as the BK2.
John.
|
No they're not John, BK2 are longer....
X-Factory XF5661 axles are fractionally shorter than the BK2 axles, which were used in the X6's.
When the BK2 axles were used they did a great job when run with lots of drrop on an X6, but were just a fraction too long, which meant that at full plunge the driveshaft could hit the diff nut still, hence when X-Factory had MIP make axles for them, they made them the correct length needed for the X6 (which is close to but a fraction shorter)