Quote:
Originally Posted by Spoolio
BUT I think I may have cocked it up as I've used the motor plate from the TC02C and I cannot get to the lower motor screw to adjust the pinion mesh. I should have realised something was not right when I got to the stage in the manual where it shows the entire rear end assembly complete with motor going onto the chassis because in my case there was no way to get it in without taking the motor of.
|
I had exactally the same problem, gearbox wouldnt go in with motor attached so i dremelled out a bit of the chassis to so as to get to the motor screw. Think it must be a design flaw in the manual or chassis.