Quote:
Originally Posted by Naushad
Thanks for all the tips so far.
Maybe I should elaborate a bit more on my situation....
It's a yokomo mx4 chassis from 1997.
I have managed to remove a lot of the screws already. But there are several ones still stuck in the chassis. The screws are Philips type and they are on the verge of softening and distorting the head.
How do I remove the head with drilling? The descriptions dont make much sense to me. I mean do you drill the sides of the head or straight down the centre?
|
Dude,
Make sure you are using the right philips driver when removing them. Theres PH1 PH2 and PH3. Unlikely to be PH3.
If there are lines between the slots of the head then its pozidriv, again, three sizes.
You should get enough purchase to remove them if you are using the right tip. It makes a huge difference. Should be strong enough to shear the head off on such small sizes provided you havent already chewed them up. Its only m3 !
Whilst im here, apologies but i just havent had five minutes to get to the post office with your old tyres due to work breakdowns. I have boxed them up and promise i will get there tomorrow regardless so they are on their way.
Regards