Quote:
Originally Posted by Chalkie
Here you go, just put a 1mm washer on the outside and use the bronze 2mm spacer on the inside next to the screw, the wheels may just rub the hub but if you put a tiny camfer on the edge of the hex fitting it's fine. If you dremel a little of the hex away or use kyosho wheels you can put the 1mm washer on the inside as well to go a bit narrower still, quite handy if the tracks slippery.
 |
Brill, the parts arrived today, this works a treat much better than filing the plastic hex down and much narrower too.
Cheers Chalkie.
Sweet!