Quote:
Originally Posted by MikePimlott
I actually think that the layshaft has a recess on to stop that pulley from going too far in.
So either the bearing width is too small, the hole the bearing sits in is too deep or the layshaft is machined slightly out of tolerence ?
You may have to fit a shim to move it out a touch.
|
You are saying all the right things Mike, because I noticed that on that first layshaft, in the instruction manual there looks like a very definate recess (or collar) as part of it.
On mine, this is almost non-existant.
I couldnt believe though that this was wrong, hence why I didnt mention it.
Maybe that is the problem then.
Without this little collar, you think that would allow the pulley to come too close tot he housing and foul on it then?