Quote:
Originally Posted by josh_smaxx
Anyone else got any setup 'coz i just cant get it to work  Iv tried pretty much everything and its still coggs bad on startup, albeit considerably better than how it was. |
I would plug the esc into the pc and set to original settings, then also make sure the settings are on normal for the timing instead of high (as this setting is for mamba motors only). It should work then, as I had the same problem with my Peak brushless motor and went through the setting proceedure on the pc and it now is a missile. also check the screws as well as they can hit the fan at the front of the motor and make it stop as well, so you need to either put smaller ones on or a metal heat sink plate in front of the motor