Quote:
Originally Posted by feasty33
Right, got it sussed & all working ok!
The wire that is needed is a yellow wire marked SIG (for signal i guess?!?).
The neg power wire i took from the Black wire going into the 40meg board, marked GND.
The pos power wire i took from the Red wire going into the 40meg board, marked VCC. I also disconnected this wire from the 40meg board to stop it transmitting.
|
Excellent work Feasty, just the thing I was looking for, posted in the how to sticky last night but no answer yet, dont need one now thanks to you. they are the same three wires I suspected last night when I posted.
Will now order a set.
One Question though, did you have to set the transmitter into ppm mode before hand or is it already there out of the box?
****UPDATE****
frsky set now ordered :-)