I am currently using the one below
Front Suspension
Toe: 0'
Ride Height: wishbones level
Camber: -1'
Castor: 5'
Kick Angle: 25' - Brass
Oil: 40
Piston: 3 Hole 1.45mm tapered
Spring: blue
Spindle Type: kit
Shock Limiters: 2mm
Shock Location: 2-middle
Bump Steer: 1mm
Camber Link: 1 - 1mm washers on tower, 1mm washers on hub
Rear Suspension
Chassis Configuration: Mid
Toe: 4'
Anti Squat: 2.5'
Roll Center: HRC
Ride Height: Driveshafts Level
Camber: -1'
Wheel Base: Medium
Oil: 32.5w
Piston: 3 hole 1.55mm tapered
Spring: pink
Shock Limiters: 0mm
Camber Link: 2-2 (2mm under tower ball stud and 1mm under hub ballstud)
Shock Locations: 2-inside
Hex Width: +1.5mm
If you don't have the tapered pistons I find that 4 hole with 2x#54 and 2x #55 in the rear and 4 hole #55 in the front work well also.
On the astro track I ran on I did find it a little understeery as can be seen from my thread about wanting power on steering.
|