Quote:
Originally Posted by def12007
Hi mate do you use a robo craft ,if so whats it like to use i may invest in one  |
Yes - Craft Robo, it's good but takes a while to get a good result as there's quite a few variables - speed / pressure / the vinyl you put through / the software etc.
I've found if you go too small it 'cocks up' and you end up with bits coming away and getting jammed in it etc - can be frustrating !
Also, I painted over the vinyl masks, then when it came to removing each element - I could not see where the joins were - took me bloody ages !
Here's an image of the design I created / the cutter file and the final side profile on the shell.
