Hi.
The engine has good compression,and i tested the glow plug which works fine.I did check the fuel lines for leaks and any air bubbles,and is is bubble free and the fuel is getting to the carb too.I installed an inline filter and have double checked its the right way round and fuel does flow through it.Some tines the car will start,but dies when i move the lever on the hand set.
This is why i think the settings are all out of wack on the carb.
The thunder tiger info on thier main website says 6.5 turns for lsn,2.5 for hsn and a 1mm gap for the idle screw setting. the engine doesnt like starting and wont idle for long at these settings.I have heard if you lean it out to much it can damage the engine,which is why im asking about the right carb settings
.