If I wanted to drill some brass block, say for some mounts, what do you reckon is the best, most economical solution? I have a Dremel 300 and a Bosch PSR 960. The Dremel 220 stand looks good...
http://www.ebay.co.uk/itm/4000140768...#ht_3810wt_905
but something like this is cheaper...
http://www.ebay.co.uk/itm/3804250877...ht_2458wt_1110
I'd be using 2.5mm bit in order to use an M3 tap.
Any advice appreciated.