Vega RB5 Diff outdrives damaged
I'm finding the outdrives are being chewed because the drive pins are just catching the outdrive, especially when the pin is top and bottom position.
I'm using UM521 wishbone, UM522 driveshaft, and UM514/um515 wide hinge pin holders. I've not drilled the additional hole in the rear wishbone for more droop, but I am using the inner hole on the wishbone.
I'm pretty sure if I use the narrow hinge pin holders it will improve the situation, but that would obviously reduce my rear overall width.
Is it a problem that you chew the diff outdrives with wide track hinge pin holders, or should the driveshaft pins engage further in the outdrives, if so how is it done.
From the wheel nut, I use the alloy wheel adapters, 0deg alloy rear hub (spacer between both bearings in rear hub), then the um522 driveshaft.
Overall width at rear is 245mm.
|