Right, got it sussed & all working ok!
The wire i was hooked up to was the wrong wire (PPM/HRS).
The wire that is needed is a yellow wire marked SIG (for signal i guess?!?).
The neg power wire i took from the Black wire going into the 40meg board, marked GND.
The pos power wire i took from the Red wire going into the 40meg board, marked VCC. I also disconnected this wire from the 40meg board to stop it transmitting.
All in all a really easy conversion.
When i get 5 minutes i'll put a full 'how to' inc pics on here that'll hopefully be useful to someone!
Dave
|