Quote:
Originally Posted by Welshy40
Waiting is not a problem. Should be a good design. The plan is to have a fixed rear layshaft pulley, using a tamiya alloy pulley or something similar.
|
yes i see the problem now. The only way to hold the original Rear pulley in is with the rear splitter hub, so with the new shaft using the b4 slipper plates, a different pulley must be used. do you have a suitable pulley in mind? also what is the diameter of the shaft itself? is it 4mm? if it is then touring car pulleys will fit. But anyway i still need to make some kind hub to fit on the shaft and the bearing 10mm (or 8mm?) ID to take up the abscence of the rear hub.. if i remeber it right the layshaft bearings are 8x14mm?