[Rick1486]

Mika, do you have an unfilled hole on the bottom of your chassis? It's directly beneath the rear left corner of the fuel tank when viewed from the front. There is a hollow tube which runs to the chassis floor, but the chassis itself is not countersunk at this point on mine, albeit it appears that this plastic shaft is hollow and should have some form of screw/bolt inserted into it.

If yours is filled would you mind letting me know what type of screw etc is in there so i can get one.

I also have the most annoying buzzing sound from my steering servo which disappears if I disconnect the linkage at the point where it joins the steering assembly - i've tried every adjustment I can think of but to no avail. Do you have any suggestions as to what I can try mate - it's a brand new servo in there. I don't know if it's to do with the height of the servo arm relative to the steering assembly or what it is. The thing I have noticed is that my steering rubs on the front right of the body when it's on with the clips as there's barely any clearance that side of the bodyshell although the other side is fine with plenty of clearance - I'm wondering if something is bent/distorted that side which may be causing me these servo problems. The bodyshell itself is looking a bit of a sorry state as it has rubbed most of the paint off in the front corners. I've emailed RB but haven't had any response from them at all. Hope you can help.


Cheers
Rick