We've been doing a large amount of design work on the X2C as a new project and we can spin off the rear end solution as a standalone option if people are interested.
Basically, the rear T-piece is replaced with 2.5mm carbon fibre, two aluminium cradles support the gearbox and the RF pivot block and an aluminium RR pivot block sits on the carbon fibre as a separate piece. This is set up to give kit toe and anti-squat (3.5 & 1.0 degrees respectively). However, anti-squat can be changed using spacers under either the RF or RR blocks. If there was demand we would also be able to produce optional blocks to change toe-in and rear track width.
All parts will be anodised (colour TBC at the moment) and the pivot blocks will be engraved with their pin centre distances.
CAD image should be below, if anyone is interested please let me know.
|