[poopers]

I’m using a Fusion LX61B Eclipse Pro charger (set to balance charge lipos at 1C or less) and a variety of 2 cell lipos from Turnigy & IP, and I’m finding my charger constantly seems to over read the cell voltages.

E.g. I charge to 4.2V per cell, disconnect the lipo from the charger and connect to my Etronix battery doctor, and it says around 4.15V per cell. I can then instantly reconnect the same battery back to my charger and it now reads around 4.15V per cell. Same thing when charging to store, I charge to 3.85V per cell then check with the battery doctor and it reads around 3.78v, connect back to charger and again it’s now reading .07V lower.

I was just wondering if anyone else had experienced this, and if it’s within a standard level of discrepancy?