I know this has been discussed to the death on here but what ball studs do I need to purchase. Can anyone give me comprehensive lists of part numbers required please?
I have purchased RPM ball cups, both short shank and long shank so just need to know what ball studs I need to buy to use with them. I assume I will need different lengths as they are not all the same on the kit, but just dont know what I need?
To be fair I havent had one pop off in a race yet and I have used it for two meetings, but they frustrate the hell out of me trying to adjust them. To try and stop them popping off when adjusting I used some black thrust grease on the threads, but now that has resulted in the thread slipping inside the ball cup so it gets to a point and wont tighten anymore, it just slips the thread and spins.