[shortcoursegoat]

Got a bit more done today, started on the rear end. went for the rear carbon tower here also along with the ally diff braces. dont know if its an issue like it is with the 410s but decided to get it just incase. found the arms were binding so cleaned the holes with a 4mm reamer an its nice now.






Next moved onto some driveshafts. have the option of different rear an front hubs, i went for 10degree on fronts and went for the standard rears instead of the +1. a set of shims come for the drive shafts marked as optional in the manual. i decided not to run these as it was a bit tight with one.









Next onto the sway bars, the kit includes some but i am running a 2.2 front an a 2.0 rear from the options kit.







Next comes the servo saver, went together easy but was very hard to tighten it to the required amount. installed the front chassis brace with it also





Rear brace, side pods an battery straps, manual isnt very clear in this part or else its my old age an lack of sight but got it figured out.



Then onto the turnbuckles, went for the lightweight option ones.





Thats as far as i am atm, will get a bit more done later. so far like the kit but the one thing im noticing compared to my hyperstar e is the lack of big 2.5mm cap head bolts. weather this is a good or a bad thing will soon be seen