Quote:
Originally Posted by MILKY
They are the same so the rubbing issue applies to both.
There is only one position the speed passion motor fits but obviously with a specific size pinion so you must have been lucky straight out of the box!I believe thinking about it it was the 21 tooth pinion that fitted on mine but dremeled it away as was still to close(however if you fit the motor and speedo first it will not cause install issues later mainly when the motor is being installed built up)
Hope it all goes ok.
MILKY
|
I have a 19 tooth pinion, and I fitted the motor afterwards. I do remember I had to rotate it for the connectors to fit.
T2C has a different motor plate to that of TC02C, X2C and the conversion kit(s), but it shouldn't make a difference.
I can re-check in a couple of days when I'll build it back to mid motor configuration.