Quote:
Originally Posted by Welshy40
OK so here is my idea on what is needed for the layshaft. Fair enough this is a mix mash of drawings I have copied and pasted but you can see my madness in here.
Idea is to use associated thrust race, bearing, spring, slipper plates and pads with my spur gear. I have added the bottom section of the hyperclutch and having a slot cut into the B4 back part of the plate so it locks into this hyperclutch part. If this is possible then the costs should be minimal except for the cost of a new layshaft.
Whats your opinion on this?
|
I don't have the hyper clutch. I think I will keep on working on my alloy pulley, and try to find the hyper clutch hub.