Just measured up the Durango wheels and drive pins and Top Force drive pins.
Durango wheels will add 2.5mm per side on to your track width.
Durango drive pins are 1.6mm dia.
Top Force drive pins are 2.0mm dia.
The 2.0mm top force pins are also quite Short in comparison to the Durango ones, and if they are not central, will effectively only drive on one side of the wheel, not both as intended.
The Durango wheels are a very snug fit on the stub axle though, and you would need a shim to prevent the drive area of the wheel rubbing on the rear hub / bearings and therefore binding.. You would probably need to use the thin serrated lock nuts too, as the stub axle thread which protrudes from the wheel is too short for using a nyloc nut.
|