Shock pump
The Tamiya one is probably the easiest and most expensive. Convienience = cost.
Another alternative - Get 3 large syringes, 3 large split pins, a 't' piece vaccuum fitting from halfords or a scrap yard and a length of pipe which fits on the end of the syringes and on to the 't' piece.
Drill same size hole as your split pins through the centre of your syringe shaft above the rubber seal about 15mm up - this is the one your shock will go in filled with oil. The other 2 syringes you need to drill the hole in the shaft half way up and the rest I will leave to your imagination.
This IS fiddly but it works and it was cheap, quiet and fast ! !
|