I am having a slight problem assmebling the gearbox on my new 210 kit.
I am building it MM4 and i am stuggling to get the two shafts through the bearings in the two idler gears. It's appears that either the bearings are slightly too small or the shaft is too large.
Here are the two gears :
I have checked everything and i'm sure there is no way i could have used the wrong parts but this is clearly not right. I have managed to get one of them about 95% through but in the even that a gear fails there is no chance i will ever be able to remove the shaft or bearings.
Has anyone else experienced this issue ?
Mark