[neil_p]

Very nice build thread Mark, little surprised that no one else has done one before.

Not sure but have you fitted the rockers upside down. Looks like the bearing is flush with the rocker looking down, the manual shows to fit with the extended bearing housing upper most. Or is this a mod?

Are you planning on any major mods straight away or just see how it goes in kit form first.

[QUOTE=Mark Headling;597054]On a side note, the shocks with clips are the preffered option as they are 100% accurate both sides, thats unless you want to the get the vernier gauges out on threaded shocks I suppose!

I don't really agree with this, you cannot get a good ride height adjustment from the spacers. The ride height jumps too much for me, even with 1 mm spacer the ride height will be a difference of approx 2-3 mm. If they were threaded you could get the ride height you want, not what you are compromised with.

Looking forward to the finished car Mark, keep it up.