If it is an FS you will find that the driveshaft dogbones are a little too short for comfort.
To get the full FS2 geometry you would need UM522 shafts (both dogbone and axle) & UM519-2 rear hubs (last is only to get the 1/2 hole spacing further out on outboard camber link.
If you want FS2-sp geometry then you will be after UM510 shafts (could just go for the dog bones if your axles are ok) and the UM519 hubs.
Obviously if your using the ali rear hubs you don't need the UM519-2 parts.
Hope that helps.
Last edited by RogerM; 20-12-2011 at 12:55 PM.
Reason: copy and paste silliness, thanks for not spotting my mistake!
|