C4.1 lay shaft tolerance
Hello,
yesterday was the first race with my new C4.1. The Car ran very well.
But I had a problem with the car. The lay shaft has a tolerance of 0,2 - 0,3mm if i move the shaft back and forth (i move the Slipper vertically up and down)
So i can adjust the gear tolerance..... Is this ok?
EDIT:
Hi again,
i replaced all lay shaft bearings several times, but i still have the same tolerance. The diff housing from my B4 do not have that tolerance, and i used the same bearings! I think it is because of the ball bearing distance in the diff housing?!
greets
|