Quote:
Originally Posted by AmiSMB
Did you use the plastic rear brace or the carbon one? Unfortunately when using the plastic one there is a lot of flex at the rear and with the new longer output cup the rear shaft can bend instead of poping out. You have to make sure that the long screws that go into the m3 nuts on top of the rear gearbox are tight and the screw that goes all the way through the brace with an m3 nut on are really tight. I had issues at the MK GP over the table top with this issue and had the rear shaft pop out and then the front shaft popping out on my V1. The other thing that can happen is the rear hoop that hold the diff can allow the rear gearbox to move up during flex and bend the shaft. To avoid this you can either use the aluminum gearbox holder or make sure that the rear diff inserts are really tightened down to make sure that the rear gearbox cannot move.
|
was useing the carbon brace and all ready useing alloy gearbox holder and useing alloy rear gearbox holder as well will check every thing is tight so not sure why its bent but thanks for the help
