Quote:
Originally Posted by mr. ed
Nice, any chance you can sell it as a bundle: with the spur and B4 parts needed?
|
sorry my friend, i cant do that, i do not have any special deal with associated to get them at cheaper price. Also i tried fitting my shaft last night and found the tolerances are all out for the bearing fit, it was way too tight. so i took some sandpaper and slowly polished it. now the end sections can fit the bearing in, but the middle section needs some more polishing. also the inner circlip groove is too narrow, i must send it back to get it widened. Another problem is the slot side for the B4 parts also is too tight and wont go in. i will use my workplace drill to clamp it and do some polishing today. as a consequence of spining the shaft manually to polish, i now have a blister on one finger on each hand (ouch). since this is a prototype i guess i expected it. i will have to fine tune the tolerances more on the minus side to get it to fit immediately. i hope i can fix it in my MID by sunday and do testing.