I know it's not the undertray but this was posted on FB a few days back
Quote:
CML Distribution
I made these little body mounts today just to see if they would work ! And I looks like they do !
I just cut a square piece of lexan out of the waste at the rear of the shell ! Approximately 40 x 60 mm then cut it down it's length !
Once I had the two pieces around 40 x 30 mm I measured 10 mm in from the edge and put a 90 degree bend in it along it's length ! Then just sandwiched it between chassis and lipo cradle !
Bit of Velcro on these and the shell and it's secure enough to go racing :-)
B4.1 front body mount and these and it's sorted !
|
