My view is that you may get a little less pin wear as there are now two of them and they are not at such a steep angle BUT not you have half the wear over 2 pins instead of one. There will be less vibration if any of the shafts or outputs are off and that means that the bearings will have an easier time as they get pushed and pulled hard with that angle of shaft. The only trouble is that you now also have two pins to retain instead of one. It is a large expense for a very little gain in my opinion.
__________________
Schumacher KC, KD, CAT XLS, CAT L1 | Team C TM2 V2, TM4, TC02 | JQ The Car | Mugen MBX6 | Losi 8T,8BE 1.5 | Durango DEX-410V4 | FTX Blaze | XRAY M18T | Kyosho STR,Surf Dude,Nexus 30 | Nimrif Makara | MFA Spear | She Devil | T-Rex 450SEV2,250SE | Ark X-400 | Protech Butterfly,Zoom 400 | Ikarus Piccolo | VW T4 | Smart 450 | KC-250 | BoltRC Kraken 5" | Emax Nighthawk 250 | Gravity 250 | S550 | Prusa i3 | TronXY X5A | Must stop collecting stuff!
|