Take a look at Gainsy's middle picture.
I cannot understand the logic of this.
The rear arm holders two middle screw holes are threaded. How does that match up with to nuts thats locked in plastic?
And on top of that the two screws needed are 30mm counter sunk, but there's no CS where they go?
On top of that: when you look in the manual, both original and online, and check the exploded views the rear arm holder has different part numbers for RM or MM. But when i look the part numbers up on the durango site, only one of them is the arm holder, and it's the arm holder thats threaded.
This all make no sense to me.
I would think the armholder had no threading and that normal flat screws were to be used.
|