I run exact same ESC mate, and only thing I would change from what you have already been advised is to increase the low voltage protection of the lipo cells.
3.0v is a bit low IMHO.
Mine is set to 3.2
Apart from that, looks fine I think.
GOod luck chum!
EDIT --- just saw that your drag brake is up too (from my setting of 5%). Your 11% will be fine, but as you probably know, a higher drag brake will increase heat on the motor, so just keep your eye to it. Only reason I say this is your pinion is quite large, so your FDR might be quite low. Sorry - prob teaching my granny to suck eggs.
