Quote:
Originally Posted by fmo
I received my 210 yesterday and built it last night - superb kit!
There is only one issue where I am unsure if I did it right - the rear end in mid motor config, see attached image. The aluminium block has threads where the long screws go through which hold the rear bumper. These screws then extend up to the nuts in the recessed plastic piece. For me it was impossible to tighten the screws in a way that there is no gap between the gearbox and the rear aluminium brace. The gap is very small, but still there.
Why are the threads in the aluminium brace? I considered to drill them out to be able to tighten the rear end together, but first wanted to ask for your advise.
How did you do it?
Thanks, Frank
|
There are two spacers that fit into the alloy block.
Have a look at the online manual. The part number in the printed manual is wrong. It should all tighten together nicely.