Quote:
Originally Posted by mikeyscott
Hi Jon,
Where did you test the car? Stotfold?
Any particular tips from the setup master?
Cheers,
Mike
|
Ha, unfortunately, i am not the set up master when I'm driving, it as it takes all my powers to focus on controlling it. Yes i was at stotfold. Car was pretty much stock and the changes i made were to swap pistons around as has been suggested, 35wt front, 27.5 rear (losi oil) and then change to a 1.5 rear squat block. Key thing in the build is to get those inserts fitted right, the markings are not easy on the eye.
Also in light of limited wheels, i managed to fit tamiya 201 wheels on the front by shimming out the excess space on the axle (these wheels take 5x10 bearings) and to fit pin drive wheels on the back by using a 3/16 x 3/8 bearing (which is a RC10 B4 front wheel bearing and a perfect fit) and a split pin.