Hi all,
All above are ready now, the body has both sides raised to allow the body not to catch the battery straps so thumb screws are not a problem anymore.The side of the body is 50mm deep so plenty of lexan to trim to allow the body to fit perfect on the sides where the valcro fits
I have also made a side pod to the rear of the window so the motor connections will not make contact with the body side anymore, i will also include a 6 inch wing with the body and both come with clear film so no over spray on that new body.The undertray has 35mm sides so again plenty of lexan to trim down if you want the tray has the kick up so fits perfect under the fron bumper and protects the chassis and most of all the electrics inside the Cr2
Any questions on above please pm.